|
ShenZhen HSM stepper Motor Electric Co., Ltd
|
Two Phase Hybrid Stepper Motor Driver
| Place of Origin: | Zhejiang, China (Mainland) |
|
|
| Add to My Favorites | |
| HiSupplier Escrow |
Product Detail
Two
Two Phase Hybrid Stepper Motor Driver
Specifications
1. High performance, low price
2 voltage 18V-50VDC.
3 For neam23 and nema17 motor
4 less than 4A current
5 300g weight
stepper motor driver:
Introduction:
M542MA is a type of two-phase hybrid stepping motor driver, the drive voltage of it is from
18VDC to 50VDC. It is designed for use with 2-phase hybrid stepper motor of all kinds with
42mm to 86mm outside diameter and less than 4.0A phase current. This circuit that it adopts
is smiliar to the circuit of servo control which enables the motor run smoothly almost without
noise and vibration. Holding torque when M542MA run under high speed is also significantly
higher than the other two-phase driver, what’s more, the positioning accuracy is also higher.
It is widely used in middle and big size numerical control devices such as curving machine,
CNC machine, and computer embroider machine, packing machines and so on.
Features:
l High performance, low price
l Average current control, 2-phase sinusoidal output current drive
l Supply voltage from 18VDC to 50VDC
l Opto-isolated signal I/O
l Overvoltage, under voltage, overcurrent, phase short circuit protection
l 15 channels subdivision and automatic idle-current reduction
l 8 channels output phase current setting
l Offline command input terminal
l Motor torque is related to speed, but not related to step/revolution
l High start speed
l High hording torque under high speed
Electrical specification:
|
Input voltage |
18-50VDC |
|
Input current |
< 4A |
|
Output current |
1.0A~4.2A |
|
Consumption |
Consumption:80W; Internal Insurance:6A |
|
Temperature |
Working Temperature -10~45°C; Stocking temperature -40°C~70°C |
|
Humidity |
No condensation, no water droplets |
|
gas |
Prohibition of combustible gases and conductive dust |
|
weight |
300G |
Function choice ( Using DIP pins to achieve this function)
1) Micro step resolution is set by SW 5,6,7,8 of the DIP switch as shown in the following table:
